GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 26)

A Series ® Lighting Controller Programmer
Chapter 8 – Lighting Group Menu
22
Viewing Outputs and Switches
1. Navigate to the Lighting Group menu:
2. Press OK to display the first lighting group (ZN01):
3. Use the arrow keys to scroll to the desired lighting
group and then press
OK to select it:
4. Press the Fn key to display the Outputs submenu:
5. Press OK to display the first output.
If there are no outputs, the following message is
displayed; jump to step 8.
6. Press the down arrow key to view the switch
associated with the selected output:
7. Continue to use the arrow keys to scroll through
the lighting outputs and their associated switches.
• If no switch is associated with a particular
output, then the following display appears:
8. After the last output/switch is displayed, the
display requests a new output:
9. Do one of the following:
• Press OK and then follow the procedure for
adding outputs and switches (described in the
next subsection).
• Press the down arrow to go back to the first
output and use the arrow keys to scroll through
the outputs and switches again.
• Press ESC to exit to the Outputs submenu.
Adding an Output
Use the following procedure to add an output:
1. Navigate to the desired lighting group and press
OK .
2. Press the Fn key to display the Outputs submenu:
3. Press OK to add a new output:
Flashing
Flashing
Flashing