Alpha Technologies Micro, Micro XL, Micro XL3 UPS - Manual (Page 25)

23 017-237-B0 Rev A
7. Push in the button on the output terminal block and then insert the wire into the terminal block until no
uninsulated wire is visible. Repeat until all the wires are installed.
8. Repeat step 7 above for the input terminal block.
9. If used, connect the following ports:
a. Ethernet port.
b. RS-232 port.
c. Dry contacts and the user inputs.
CORRECT
INCORRECT
Tape temperature sensor to inside
face of one of the centre batteries
Battery
temperature
sensor
Ethernet port
RS-232 port
Dry contacts
Figure 16 — Connecting the front panel ports