Alpha Technologies Micro, Micro XL, Micro XL3 UPS - Manual (Page 77)

75 017-237-B0 Rev A
The default command can be issued via the RS-232 HyperTerminal or the RS-232 GUI as follows:
• RS-232 HyperTerminal – type default:all and press Enter. Enter the password and the Alpha Micro returns
*default as confirmation.
• RS-232 GUI – From the UPS Maintenance > Unit Configuration screen, click the Restore Defaults button.
Enter the password to execute the command.
6.11.4 Restoring All Parameters to Default Values
The purpose of this command is to reset the Alpha Micro to the factory default state. See Table P for a list of pa-
rameters that will be restored to their default values.
CAUTION!
This command resets all parameters that are user-configurable. All previously pro-
grammed operation will be lost. Implement a backup plan for mission critical opera-
tions. This command is password protected.
Figure 62 — Restore all default commands