Fig. 7-9, dpm attached to sheet metal, Fig. 7-10, dpm / im connection, Fig. 7-11, completed assembly – Alpha Technologies DSM3 for XM2 - Technical Manual User Manual
Page 59: Fig. 7-8, the 18-pin jumper installed, Fig. 7-9, dpm 18-pin header, Fig. 7-10, dpm attached to sheet metal, Fig. 7-11, dpm / im connection, Fig. 7-12, completed assembly, 0 installation
59
745-814-B8-001, Rev. C (03/2014)
7.3
DPM Installation Procedure, continued
6. Plug the supplied 18-pin jumper into the header on the Inverter Module.
Fig. 7-9, DPM 18-pin header
(Alpha p/n 540-581-19)
Fig. 7-8, The 18-pin jumper installed
When replacing an existing DPM do not reuse the existing 18-pin connector. Use the18-pin connector supplied
with the DPM.
NOTE:
6
7. Attach the DPM to the sheet metal with the supplied 6-32 screws, see Fig. 7-9.
8. Line up the 18-pin jumper with the header on the Inverter Module and gently push the DPM into
the inverter module.
9. Fasten the DPM to the Inverter Module
by tightening the two captive screws. It is
recommended that the screws be tightened
alternately, a few turns at a time so the
Communications Module aligns in parallel to the
Inverter Module.
10. Reinstall the Inverter Module and make front panel
connections (tamper, temperature sensor, battery,
RF, etc.).
11. If not yet done, record the cable modem MAC
address from the front of the unit and report it to
the network manager for network provisioning.
Fig. 7-12, Completed assembly
7.0 Installation
Fig. 7-11, DPM / IM connection
Fig. 7-10, DPM attached to sheet metal