Alpha Technologies DSM3 for XM2 - Technical Manual - Manual (Page 75)

75 745-814-B8-001, Rev. C (03/2014)
9.2 Verifying Correct Hardware Interconnection
The BAT A/B and BAT C/D LED indicators on the front panel of the DSM3 Series unit should illuminate
solid green once the battery wiring harnesses are correctly installed.
The DSM3x model provides both BAT A/B and BAT C/D LED indicators and battery harness connectors
(supports a maximum 4 battery strings). The DSM3 model provides only the BAT A/B LED indicator and
battery harness connector (supports a maximum 2 battery strings).
NOTE:
From the Power Supplies and Batteries section of "General" tab of the DSM3 Series Web page, the
following screen will be visible and the parameters shown will be available for viewing and verification.
To test hardware interconnection using the Ethernet port, verify valid values for Output Voltage, Output
Current and individual battery voltages.
9.0 Start Up and Verification
Fig. 9-2, Power Supply Section - General Page