Program – Burkert Type 1150 User Manual
Page 65
1150 - 63
C
ONFIGURATION
Value / selection
Description
Start at time
P
No
Yes
Starts the program after an adjustable start delay, or at a time that can be
defined (start with time delay).
Setting the Clock:
(see Chapter Device data)
Program end time
P
- 1 to 0 to 9999 s
Duration of program end signal
-1 = continous signal until acknowledgement
(see Chapter Outputs)
Function control
P
(.../Controller 1 to 4, .../1 to 16. Limit comparator
Generator control
Control contact 1
...
Control contact 8
Defines when controllers and limit comparators are active.
Generator control:
This function is only active in "Automatic mode";
Otherwise as per defined system status for the basic status in the setup program.
Control contact:
This function is only active if the control contact is in the "ON" condition.
Program / ...