Burkert Type 1150 - Manual (Page 85)

1150 - 83
C
ONFIGURATION
Recording
The recording function permits the visualization of up to four analog and three logic
signals. The signal sources are defined here.
Configuration
Analog inputs
Controller
Generator
Limit comparators
Outputs
Logic functions
Math / logic
C-level
Display
Interfaces
Device data
Recording
Analog value 1 (2 to 4) / ...
Value / selection Description
Function
(Analog selector)
Switched off Recording of analog signals
Scaling start Defines the lower and upper limit on the y-axis.
The screen templates "Recording" (operating loop) can be used to switch
between the scaling of the analog values for the graphical display of the traces. - 1999 to 22 to + 9999
Scaling end
- 1999 to 22 to + 9999
Decimal place
XXX.X
Unit
(4-character text)
% Any 4-character sequence can be specified
Value / selection Description
Logic value 1, logic value 2, logic value 3
(Binary selector)
Switched off Recording of logic signals
Storage rate
1 to 6 to 60 sec Defines the time span between the measurement points.