Burkert Type 1150 - Manual (Page 69)

1150 - 67
C
ONFIGURATION
Outputs
Configuration of the instrument outputs are subdivided into analog outputs (max. 6)
and logic outputs (max. 12). Display and numbering of the outputs depends on the
assignment of the output slots Output 1- 6.
Configuration
Analog inputs
Controller
Generator
Limit comparators
Outputs
Logic functions
Math / logic
C-level
Display
Interfaces
Device data
Recording
Numbering of the outputs
Slot
Plug-in board with
1 analog output 1 logic output 2 logic output
Output 1 Analog output 1 Logic output 1 Logic output 1+7
Output 2 Analog output 2 Logic output 2 Logic output 2+8
Output 3 Analog output 3 Logic output 3 Logic output 3+9
Output 4 Analog output 4 Logic output 4 Logic output 4+10
Output 5 Analog output 5 Logic output 5 Logic output 5+11
Output 6 Analog output 6 Logic output 6 Logic output 6+12
Analog outputs / Analog output 1 (2 ... 6) / ...
Signal for range: If the output is a controller output, the controller switches over to manual
mode and produces an output level that can be defined.
see Chapter “ Controller”
Value / selection Description
Function
(Analog selector)
Analog inp. 1
Factory-set for analog output 2 to 6: Switched off
Signal
0 to 10 V
2 to 10 V
0 to 20 mA
4 to 20 mA Physical output signal
Signal for range
0 to 101 % Signal on going above / below range
NOTE