Burkert Type 8076 - Manual (Page 12)

10
Description
5.2.2. construction of the 8036
The 8036 flowmeter comprises:
A
B
C
A: an S030 fitting including the paddle-wheel flow sensor.
Set in rotation by the flow, the 4 permanent magnets integrated in the vanes of the
paddle generate pulses, the frequency of which is proportional to the flow speed of
the fluid. A conversion coefficient specific to each pipe (material and diameter) is
necessary to establish the flow rate value associated with the measurement.
The conversion coefficient (Factor K) expressed in pulses per litre is given in the user
manual for the fitting used.
B: an acquisition / conversion module for the process values measured:
• acquisition of the pulse frequency
• conversion of the frequency measured into flow rate units
C: a display module with navigation button used to read and/or configure the para-
meters of the device. The display module is not delivered with all the versions of the
flowmeter but it is available as an accessory.
See chap. 11.
5.2.3. construction of the 8076
The 8076 flowmeter comprises:
A
B
C
A: an S070 fitting including the flow sensor with oval gears.
Set in rotation by the flow, the magnets integrated in the oval gears generate pulses,
the frequency of which is proportional to the volume of fluid. A conversion coefficient
specific to each pipe (material and diameter) is necessary to establish the flow rate
value associated with the measurement.
The conversion coefficient (Factor K) expressed in pulses per litre is given in the user
manual for the fitting used.
B: an acquisition / conversion module for the process values measured:
• acquisition of the pulse frequency
• conversion of the frequency measured into flow rate units
C: a display module with navigation button used to read and/or configure the para-
meters of the device. The display module is not delivered with all the versions of the
flowmeter but it is available as an accessory.
See chap. 11.
English
Type 8026- 8036- 8076