Burkert Type 8076 - Manual (Page 23)

21
Assembly
7. Assembly
7.1. safety instructions
danger
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source before carrying out work on the system.
• Observe all applicable accident protection and safety regulations for electrical equipment.
Warning
risk of injury due to non-conforming assembly.
• The device must only be assembled by qualified and skilled staff with the appropriate tools.
risk of injury due to unintentional switch on of power supply or uncontrolled restarting of the
installation.
• Take appropriate measures to avoid unintentional activation of the installation.
• Guarantee a set or controlled restarting of the process subsequent to any intervention on the device.
7.2. unscrewing the cover
note
the tightness of the device is not guaranteed when the cover is removed.
• Once the cover is removed, prevent the projection of liquid inside the housing.
the device may be damaged if a metal component comes into contact with the electronics.
• Prevent contact of the electronics with a metal component (screwdriver, for example).
→
To unscrew the cover, use your hand or a tool which can be
used as a lever, taking care not to scratch the glass.
→
Turn the cover until fully unscrewed.
Figure 7 : Unscrewing the cover
English
Type 8026- 8036- 8076