Burkert Type 8076 - Manual (Page 49)

47
Adjustmentandcommissioning
The data transfer is impossible from a device having an acquisition / conversion module for the process
values measured with a V2 software version to a device having an acquisition / conversion module for the
process values measured with a V1 software version.
• On each device, check the software version of the acquisition / conversion module for the process
values measured, in the menu "Info -> Software -> Versions -> Main".
When transferring data from a device having an acquisition / conversion module for the process values
measured with a V1 software version to a device having an acquisition / conversion module for the
process values measured with a V2 software version, the following data are not transferred:
• the access codes to the menus,
• the wire mode of the outputs (fonction "HWMode").
• Function "DOWNLOAD" is only present if an "UPLOAD" has been successfully carried out.
• Never interrupt a data transfer else the device could be damaged.
System Param Up/Download Download
Upload
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
Downl. Yes/No
Upload Yes/No
The following data can be transferred from a device to another device of the same type:
• user set data of the PARAM menu (except the date, the time, the contrast and brightness levels for the display),
• K factor of the fitting,
• user set data of the DIAGNOSTIC menu,
• the access codes to the menus.
DOWNLOAD: transfer the data previously uploaded in the display module by means of the "UPLOAD" function.
The parameters transferred are used by the device as soon as the message “Download OK” is displayed.
UPLOAD: upload data from the device to the display module.
English
Type 8026- 8036- 8076