Burkert Type 8076 - Manual (Page 52)

50
Adjustmentandcommissioning
"slow" "fast" "none" filter
150 ms 6 s
t
30 s
t t
Figure 39 : Filter curves
9.12.5. choosing the units for the totalizers displayed in process
level
See chap. 9.10 to access the Param menu.
The totalizers are saved if a power cut occurs.
Display Param Totalizers Total1 / Total 2 Unit Liter
m3
gal
Igal
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
UNIT: Choose the volume unit in which the value of totalizer 1 and totalizer 2 respectively is displayed.
9.12.6. Displaying the lowest and highest values measured
See chap. 9.10 to access the Param menu.
Display Param Min/Max Enabled
Disabled
PVar Flow_L
Flow_m3
Flow_gal
Flow_Igal
Unit: /h
/min
/s
Hz If PVar = Freq.
If PVar ≠ Freq.
Status
Freq.
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
STATUS: Choose to display (choice “Enabled”) or not display (choice “Disabled”) the minimum and maximum
values measured since the last reset.
PVAR: Choose a physical parameter (volume unit of the flow rate or input frequency), the minimum and maximum
measured values of which are displayed in Process level.
UNIT: Choose the preferred time unit in which the min. and max. measured flow rate values are displayed.
Take care to choose the time unit according to the flow rate in the pipes as the display indicates a
maximum flow rate of 9999 volume units/time units. See chap. 9.12.4.
English
Type 8026- 8036- 8076