Burkert Type 8035 - Manual (Page 96)

94
Operatingandfunctions
REtURN
OUtPUt
0......9
DO4 StAtE
Configuring the transistor output DO4 to transmit the device
state. See chap. “9.7.26”.
PULSE
ALARM
WARNiNG
END DOSE
Configuring the transistor output DO4 to send a pulse when a
dosing is finished. See chap. “9.7.21”.
Configuring the transistor output DO4 to switch when an
alarm is generated during or at the end of a dosing. See chap.
“9.7.19”.
Configuring the transistor output DO4 to switch when a
warning message is emitted by the device. See chap. “9.7.20”.
Configuring the transistor output DO4 as a pulse output
proportional to a volume or a mass. See chap. “9.7.22” and
“9.7.23”.
Figure 76: Diagram 2/2 of the "OUTPUT" parameter of the Parameters menu
9.7.19 Configuring the transistor output Do1 or Do4 or the relay
output Do3 to switch when an alarm is generated during
or at the end of a dosing
An alarm is generated during or at the end of a dosing (can be parametered, see chap. “9.7.16” et “9.7.17”).
The generation of an alarm can be signalled by the switching of the output DO1 and/or DO3 and/or DO4.
The relay output DO3 can be configured to switch when an alarm is generated during or at the end of a
dosing, if the output is not configured to control an auxiliary valve. See chap. “9.7.25”.
REtURN
OUtPUt DO1 ALARM
DO2
iNV YES
iNV NO
0......9
→
Choose the operating, inverted or not inverted, of the
output.
→
Confirm.
DO3
DO4
DO4
Figure 77: Configuring the output DO1 or DO3 or DO4 to signal the generation of an alarm during or at the end of a
dosing
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER to save the settings or not and go back to the Process level.
English
Type 8025 - 8035 BATCH