Installation and servicing, Safety advisory for the user, Hazard warnings – Fluid Components International CMB User Manual

Page 11: Danger, Warning

Advertising
background image

1.1

Installation and servicing

The devices described in this manual are to be installed and serviced by qualified technical personnel.

Warning
Before servicing the device, it must be completely switched off, and disconnected from all
peripheral devices. The technician must also check to ensure that the device is com-
pletely off-circuit. Only original replacement parts are to be used.


Fluid Components International accepts no liability for any loss or damage of any kind arising
from improper operation of any product, improper handling or use of any replacement part, or
from external electrical or mechanical effects, overvoltage or lightning. Any such improper opera-
tion, use or handling shall automatically invalidate the warranty for the product concerned.


In the event a problem arises with your device, please contact us at one of the following numbers to ar-
range to have your device repaired:

Phone: 760 – 744 - 6950
Fax:

760 – 736 - 6250


Contact our customer service department if your device needs repair or if you need assistance in diag-
nosing a problem with your device

1.2

Safety advisory for the user

The present document contains the information that you need in order to operate the CMB Series Coriolis
mass flow meter properly. This document is intended for use by qualified personnel. This means person-
nel who are qualified to operate the device safely, including electronics engineers, electrical engineers, or
service technicians who are conversant with the safety regulations pertaining to the use of electrical and
automated technical devices and with the applicable laws and regulations in their own country.

Such personnel must be authorized by the facility operator to install, commission and service the product
described , and are to read and understand the contents of the present operating instructions before
working with the device.

1.3 Hazard

warnings

The purpose of the hazard warnings listed below is to ensure that device operators and maintenance
personnel are not injured and that the flowmeter and any devices connected to it are not damaged.

The safety advisories and hazard warnings in the present document that aim to avoid placing operators
and maintenance personnel at risk and to avoid material damage are prioritized using the terms listed
below, which are defined as follows in regard to these instructions and the advisories pertaining to the
device itself.

1.3.1

Danger

means that failure to take the prescribed precautions will result in death, severe bodily injury, or sub-
stantial material damage.

1.3.2 Warning

means that failure to take the prescribed precautions could result in death, severe bodily injury, or sub-
stantial material damage.

CMB & CT OPERATING MANUAL
Part No 06EN003384 rev. 1.6

Page 11 of 106

Advertising