Fluid Components International CMB - Manual (Page 14)

3. The CMB sensor
3.1 Application domain of the CMB sensor
The sensor is intended for use solely for direct and continuous mass flow measurement of liquids and
gases, irrespective of their conductivity, density, temperature, pressure, or viscosity. The sensor is also
intended for use for the direct and continuous mass flow measurement of chemical fluids, suspensions,
molasses, paint, varnish, lacquer, pastes and similar materials.
[ ]
v m F
C
× ⋅ ⋅ = ω
2
3.2 Mode of operation
3.2.1 Measuring principle
The Coriolis mass flowmeter is based on the
principle whereby in a rotating system a force
(known as the Coriolis force) is exerted on a
mass at a rotation point that is moving towards
or away from this point.
3.2.2 System configuration
The flowmeter consists of a sensor that is mounted in a pipe, and a transmitter (see Section 5
Application domain of the CT
on pp. 30), that can be directly mounted on the sensor or installed sepa-
rately (e.g. on a wall).
The transmitter oscillates the flow tubes in the sensor over an excitation coil and picks up, via the sensor
coil, the measuring signal which is proportional to the mass flow. After being temperature compensated,
the measuring signal is converted into an analog output signal that is consistent with the measuring range
setting.
3.2.3 Input
Measured variables: mass flow, density, temperature; volume flow is calculated
3.3 Custody transfer operations
Units designated for custody transfer operation may be certified in accordance to the local or national
ordinance. Transmitters ordered for custody transfer applications incorporate special tamper-proof soft-
ware, sealed and certified, that prevents the reset of the internal totalizer.
Page 14 of 106
CMB & CT OPERATING MANUAL