INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 10)

10
SOFTWARE INSTALLATION
4. With the General
menu tab/screen
displayed, select
“Internet Protocol
(TCP/IP),” then
click “Properties.”
5. In the “IP address” field on the subsequent Properties screen, enter
an IP address beginning with “192.168.2” and ending with a value
between 2 and
254 (as shown).
In the “Subnet
mask” field, enter
“255.255.255.0.”
Click “oK.”
NOTE: If you forget
the IP address of the
camera after you
change it, there are
two ways to recover it:
• Reset back to
192.168.2.3 (and
lose all settings);
• Ask your network
administrator to
check the dHCP
release table (if
the camera was
set to obtain the
IP address by
DHCP).