INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 17)

17
WEB MANAGEMENT INTERFACE
3. The NSC18-WN Pan/Tilt Network Camera
requires a special ActiveX control (plug-in)
in order to work properly. Right-click on the
message in the address bar to display an
options menu (right), then click “Install ActiveX Control...” to continue.
4. When the Security Warning screen displays (below), click “Install.”
You should now be able to view live images on the Camera screen
(see 3.2 Camera Settings below).
NOTE: If one or both of the messages
shown here display, your computer may
not have the display capability that this
camera requires (refer to Section 6
Specifications) or you may not have
Microsoft DirectX installed (which you can download
from Microsoft’s Web site: www.microsoft.com). In
some cases, your computer displays the image from
the camera correctly but you still see these messages.
If this happens, you can just ignore them.
3.2 camera settings
As mentioned, the first screen that displays after you log on to the Web
management interface is the Camera screen (below). This is the only
one of the seven options on the horizontal menu bar (just above the
image area) that presents the live camera image. You can, of course,
click on the Camera option from anywhere within the interface to return
to the live-image display.