INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 4)

4
REGULATORY STATEMENTS
regulaTory STaTemeNTS
eU Declaration of conformity
This device complies with the essential requirements of the R&TTe
Directive 1999/5/EC. This device is a 2.4 GHz wideband transmission
system (transceiver) intended for use in all EU member states and EFTA
countries, except in France and Italy, where restrictive use applies.
In Italy, the end-user should apply for a license at the national spectrum
authorities in order to obtain authorization to use the device for setting
up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France,
and in some areas the RF output power may be limited to 10 mW eIRP
in the frequency range of 2454 – 2483.5 MHz. For detailed information,
the end-user should contact the national spectrum authority in France.
feDeral commUnications commission interference
statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. operation is
subject to the following two conditions: 1) This device may not cause
harmful interference, and 2) This device must accept any interference
received, including interference that may cause undesired operation.