INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 7)

7
COMPONENTS & CONNECTIONS
1.2 Back / connections
1. Connect one end of the included
Ethernet cable (or a similar one)
to your local area network and
the other end to the lAN port.
NOTE: You can skip this step
if you plan to use a wireless
lAN only.
2. Plug the included power
adapter into an A/C outlet
and connect it to the 12VdC
power jack.
3. Attach the two included
antennas to the connectors
(shown already attached
at right).
4. Press the WPS buttons
on both the camera and
your access point(s) to
establish Wi-Fi Protected
Security between the devices.
5. If desired, connect an external speaker to the 3.5mm Audio Out jack.
6. As needed or desired, insert an SD (secure digital) or SDHC (high-
capacity) card into the SD slot to download up to 8 GB of video files.
NOTE:
Refer to Section 3.5.5 Motion Detection / SD Card Configuration
and Section 3.8 SdHC.
7. Position the camera in a secure location (see Safety Precautions
above) and aim it as desired.