INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 16)

16
WEB MANAGEMENT INTERFACE
On the Security screen (above), you can change the camera’s name
and password (as on the Login screen, the username is always “admin”
and can’t be changed). Be sure you enter the same password in both
the “New Password” and “Confirm Password” fields; otherwise, you’ll
be prompted to enter the new password again. Click “oK” to save the
settings; click “Cancel” to discard changes.
3 Web maNagemeNT iNTerfaCe
3.1 logging on
With new camera purchases, there should be no problem with the login/
logon procedures. Remember, however, that if you have obtained this
camera from another party after initial installation, then you’ll probably
need to reset the password.
1. With the camera powered on, launch your Web browser and enter
the IP address of the camera in the address bar.
2. When the Internet Camera login
screen displays (right), enter a
username and password and
click “oK.” As before, the “User
Name” and “Password” defaults
are “admin” and “1234.” NOTE:
If this login screen doesn’t
display, go back and re-enter
the IP address as necessary.
once you’ve logged in properly,
your browser should display the
“This site might require the following ActiveX control...” message, as
shown below.