Lk series – General Pump LK Repair Manual User Manual
Page 10
Advertising
GENERAL PUMP
A member of the Interpump Group
LK SERIES
Lay the crankshaft on the bottom of the crankcase. Separate the bearing support cover from the bearing,
using a striking hammer (pos. 1, fig. 25).
Unscrew the attachment screws of the left and right PTO bearing cover (pos. 1, fig. 26) and slip the two cov-
ers off the PTO shaft. To help with their removal, use 3 M8 grub screws or screws (pos. 1, fig. 27) as
extractors.
Apply an M16 threaded pin to one end of the crankshaft (pos. 1, fig. 23) and, while keeping it raised, take out
the bearing support cover complete with bearing and O-ring (pos. 1, fig. 24). To help with their removal, use 2
M10 grub screws or screws (pos. 2, fig. 23) as extractors. Repeat the operation on the other side
Page 10
Advertising