Lk series – General Pump LK Repair Manual User Manual
Page 35
GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 35
2.2.2 Assembling the Head - The Valve Assemblies
Check the state of wear of the various components very carefully and replace them if
necessary. At each inspection of the valves, replace all the O-rings, both for the valve
assemblies and for the valve plugs.
Before repositioning the valve assemblies, clean their seats in the head, located by the
arrows (pos. 1, fig. 115), and then dry these seats completely.
Proceed with the assembly, following the reverse of the disassembly procedure shown in 2.2.1.
Assemble the inlet and outlet valve assemblies (fig. 116 and fig. 117), taking care not to reverse the springs
that were previously removed.
To facilitate insertion of the valve holder into the seat, place a pipe on the horizontal flat surface of the
holder (fig. 118) and use a mallet/striking hammer around the entire circumference.