General Pump LK Repair Manual - Manual (Page 29)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 29
Insert the assembly into the casing and into the seat provided, making sure that the cover completely enters
its seat (pos. 1, fig. 95), being careful not to damage the lip of the radial seal ring. Screw in the oil seal covers
using 2 M6X30 grub screws (pos. 1, fig. 96).
Tighten the screws with a torque wrench as shown in section 3, “Screw Tightening Settings”.
Position the spray guard and the spray guard spacer ring in the seat on the piston head stem (pos. 1,
fig.97and fig. 98).
Insert O-rings on the two inspection covers (pos. 1, fig. 99) and mount the covers using 4 M6X14 screws
(pos. 1, fig. 100).