General Pump LK Repair Manual - Manual (Page 21)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 21
Mount one of the PTO bearing covers (left or right) on the pump casing (pos. 1, fig. 67) and attach it with four
M8X30 screws (pos. 1, fig. 68).
Be careful of the direction of assembly of cover. The lubrication hole in the cover must
correspond to the hole in the casing.
Repeat the operations on the other side:
Insert the internal ring (pos. 1, fig. 61) and external ring (pos. 1, fig. 62) of the second bearing.
Mount the second PTO bearing on the pump casing (pos. 1, fig. 67) and attach it with 4 M8X30 screws (pos.
1, fig. 68).
Tighten the 4 screws with a torque wrench, as shown in section 3, “Screw Tightening Settings”.
Pre-assemble the two bearing covers:
Insert the bearing using a mallet or striking hammer (pos. 1, fig. 69) until 4 to 4.5 mm of the bearing is still
protruding, as shown in fig. 70