General Pump LK Repair Manual - Manual (Page 24)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 24
The pressure bushing must be inserted dry (no lubricant).
Insert the bushing until the outside (conical) surface perfectly couples with the inside of the bearing. During
insertion, make sure that the bearing stays in contact with the crankshaft shoulder.
Repeat the operation on the other side.
Insert the bushing locking flanges into the conical bushings (pos. 1, fig. 78). Apply a sufficiently long (30-40
mm) M16 screw to the M16 hole on the crankshaft and screw it in, until the flange is touching the bushing
(pos. 1, fig. 79). DO NOT TIGHTEN THE SCREW.
Repeat the operation on the other side.
Remove the tool for locking the connecting rods (F27566200) (pos. 1, fig. 40).