General Pump LK Repair Manual - Manual (Page 27)

GENERAL PUMP
A member of the Interpump Group
LK SERIES
Page 27
Repeat the operation on the other side.
Remove the M16 screw from the crankshaft. Screw the two bushing locking flanges onto the crankshaft using
4 M12X25 screws (pos. 1, fig. 87).
Apply LOCTITE 243 to the threads of the M12X25 screws (pos. 1, fig. 87).
Tighten the screws with a torque wrench, as shown in section 3, “Screw Tightening Settings”.
Remove the anti-rotation shim from under the shank of the central connecting rod.
Mount the two bearing covers (with their O-rings) (pos. 1, fig. 89) using 6 M8X20 screws (pos. 1, fig. 90).
Tighten the screws with a torque wrench, as shown in section 3, “Screw Tightening Settings”.