Watlow EZ-ZONE ST - Manual (Page 95)

Watlow EZ-ZONE ® ST • 93 • Appendix
Declaration of Conformity
CE DOC EZ-ZONE ST-01-10 Page 1 of 2
Series EZ-ZONE ® ST Tower
WATLOW
an
ISO 9001
approved facility since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Designation:
Series EZ-ZONE ® ST Tower
Model Numbers: ST, followed by K, B, P, E, H, D, J or C, followed by A, L or B, followed
by A, B or F, followed by L, H, 1, 2 or 3, followed by any letter or
number, followed by A – H, J – N, P, R, S or T, followed by A, B, C, D,
E or F followed by any three numbers or letters.
Classification: Temperature control, Installation Category II, Pollution degree 2, IP20
Rated Voltage and Frequency: Control 100 to 240 V~ ac or 24 to 28 V� ac or dc (ac = 50/60 Hz)
Load 24 to 240 V~ ac or 48 to 600 V~ ac zero cross, or
Load 100 to 240 V~ ac or 260 to 600 V~ ac phase angle 3 .
Rated Power Consumption:
Control 12 VA, Control with Contactor 50 VA, Control with external
contactor 140 VA. Load Current 25, 40 or 75A depending upon SSR
and heatsink used. (see derating curve)
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1 2006 Electrical equipment for measurement, control and laboratory
use – EMC requirements (Industrial Immunity, Class A
Emissions 1 ). Not for use in a Class B environment without
additional filtering.
EN 61000-4-2 1996 +A1,A2:2001 Electrostatic Discharge Immunity
EN 61000-4-3 2006 Radiated Field Immunity
EN 61000-4-4 2004 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5 2006 Surge Immunity
EN 61000-4-6 1996
+A1,A2,A3:2005
Conducted Immunity
EN 61000-4-8 1994 +A1, 2001 Magnetic Field Immunity
EN 61000-4-11 2004 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2 4 2006 Harmonic Current Emissions
EN 61000-3-3 2 2005 Voltage Fluctuations and Flicker
SEMI F47 2000 Specification for Semiconductor Sag Immunity Figure R1-1
1 NOTE 1: Use of an external filter is required to comply with conducted emissions limits for load
terminals. For 230 Vac or less, use Watlow P/N 14-0019 or Crydom P/N 1F25 filters. For voltages
up to 440 Vac use Watlow P/N 14-0020 or Crydom P/N 3F20 filters. A Line Impedance Stabilization
Network (LISN) was used for conducted emissions measurements.
2 NOTE 2: To comply with flicker requirements cycle time may need to be greater than 175
seconds if Load Power is ≤ 16A to comply with standard, or the maximum source impedance
needs to be determined. Source impedance shall meet EN 61000-3-11 requirements for load
currents > 16A. Control module power complies with 61000-3-3 requirements.
Declaration of Conformity