HATZ Diesel 4M42 - Manual (Page 8)

▪ Installation of the machine in moving equipment (e.g. vehicles, trailers) or
in closed rooms without additional measures to handle supply air, extract
air and exhaust.
▪ Improper operation at variance with DIN 6271 and DIN ISO 8528 (climate,
load, safety).
Residual risks
Residual risks result during daily use and in association with maintenance
work.
These residual risks are described in the chapter 3.2.2 Machine-specific
safety instructions for operation, page 14 and in the chapter 3.2.3 Ma-
chine-specific safety instructions for maintenance work, page 16, and in
other parts of the manual directly preceding the affected descriptions and in-
structions.
3.1.2 Machine user or machine manufacturer obligations
Machine manufacturer obligations
If you have an engine that is not yet installed in a machine, it is imperative
that you follow the Assembly Instructions for HATZ Diesel Engines be-
fore installing the engine. These assembly instructions contain important in-
formation on how to safely install the engine and are available at your near-
est HATZ service station.
It is prohibited to start the engine before it is fully installed.
In addition, please note that it is prohibited to start up the machine before it
has been determined that the machine into which this engine is installed ful-
fills all safety-related requirements and legal regulations.
User obligations
The user is obligated to only operate the machine while it is in perfect condi-
tion. The user must check the condition of the machine before using it and
ensure that any defects are eliminated before it is taken into service. Opera-
tion of the machine while identified defects exist is not permitted. The user
must also ensure that the information contained in the Operator's Manual
has been read and understood.
Obligations of the operating and maintenance personnel
Personnel assigned with operating and maintaining the machine must have
read and understood the Operator's Manual or must be able to demonstrate
the necessary qualifications for working with this equipment, acquired in
training/instructional courses. No one may work with the machine without the
necessary qualifications, even if for just a brief period.
All work performed on the machine must be in compliance with the informa-
tion provided in the Operator's Manual.
Safety 2-4L41C, 2-4M41, 2-4M41Z, 4L42C, 4M42
8 Operator's Manual HATZ