HATZ Diesel 4M42 - Manual (Page 95)

Type of fault Possible causes Remedy Chapter
Starter speed is too
low:
▪ Oil is too vis-
cous.
Change the engine
oil and add oil of
the right viscosity
class. 4.3 Engine
oil, page 24
8.2.5
Change the
engine oil,
page 64
▪ Insufficiently
charged battery.
Check the battery
and contact the
service center if
necessary. 3.2.4 Elec-
trical equip-
ment,
page 18
Machine is not un-
coupled. If possible, sepa-
rate the engine
from the machine
by uncoupling it.
The starter does
not switch on and
the engine does
not turn. Irregularities in the
electrical equip-
ment:
▪ Battery and/or
other cable con-
nections are in-
correctly con-
nected.
▪ Cable connec-
tions are loose
and/or oxidized.
▪ Battery is faulty
and/or not load-
ed.
▪ Faulty starter.
▪ Faulty relay,
monitoring ele-
ments, etc.
Check the electri-
cal equipment and
their components.
Contact the Hatz
service station. 3.2.4 Elec-
trical equip-
ment,
page 18
The engine starts,
but does not con-
tinue running after
the starter is
switched off. The speed control
lever is not suffi-
ciently set to the
Start direction. Set the lever to the
Start position. 7.5 Starting
the engine,
page 37
Machine is not un-
coupled. If possible, sepa-
rate the engine
from the machine
by uncoupling it.
2-4L41C, 2-4M41, 2-4M41Z, 4L42C, 4M42 Faults
HATZ Operator's Manual 95