KANOMAX 6162 Anemomaster - Manual (Page 19)

2. Basic Operation 13
2.6 Printing Hard Copy of the Monitor Screen
2.6.1 What you need
★ Printer (sold separately) ····· Recommended model is DPU-201GS (Seiko Instruments Inc.)
★ Cable to connect the instrument and a printer (sold separately)
2.6.2 Printer Setting
Switch No. Function Anemomaster Printer
SW 1 Word Length 8 bit ON
SW 2 Parity Yes/No None ON
SW 3 Parity Setting None ON
SW 4∼6 Baud Rate 4800 Table Below
Baud Rate SW 4 SW5 SW6
4800 OFF ON OFF
2.6.3 Signal Cable Connection
Anemomaster Printer
Signal Pin No. Signal Name Signal Pin No. Signal Name
3 (orange) TXD 3 DATA
1 (brown) GND 5 GND
4 (yellow) CTS 8 BUSY
2.6.4 Operation Procedure
1. Connect the instrument (RS-232C output terminal) and a printer.
2. Turn on both of the instrument and the printer.
3. Confirm that the Anemomaster’s display is an initial screen.
4. Press HOLD key to hold the display screen.
5. When the display is on hold, press PRINT key.
To Halt Printing Temporarily and To Cancel Printing
Š Temporary Halt: To stop printing temporarily, press PRINT key while printing.
To recommence printing, press PRINT key again.
Š Cancel Printing: To stop printing temporarily, press PRINT key while printing.
When the printing is halted, press MENU key.
As the menu screen will be displayed, select 1. MONITOR.
Press PRINT key when this
screen (on hold) is displayed.
08.07.01
hold 10:26:40
5.38 m/s
25.7 °C