KANOMAX 6162 Anemomaster - Manual (Page 40)

5. Data Output 34
5.2.4 To Transfer Memory Data (Measurement Data Stored in Memory)
DATA OUTPUT mode in menu screen
Getting Ready for Transferring Memory Data
Display Key Procedure
MENU (1) Press MENU key.
△ , ▽
SET
(2) Select 3. DATA OUTPUT.
Then press SET key.
△ , ▽
SET
(3) Select 3. COMPUTER.
Then press SET key.
Ready! (4) When the screen shown on the left is on the display, start (RUN)
the program on your computer.
To Stop Transferring: MENU key
Internal
Memory
Start
Transferring
An error message will be displayed when…
1. RS-232C cable is not connected.
2. The wiring connection of the connector is not correct.
Referring to the example of connecting to the host computer, check the
wiring connection. (See 5.2.1 Connection Example (P.32))
3. Data cannot be retrieved.
Baud rate may not be set correctly.
Confirm the baud rate of the host computer and the instrument.
< MENU >
1. MONITOR
2. MEASUREMENT
3 . DATA OUTPUT
4. MEMORY CLEAR
5. UTILITY
< DATA OUTPUT >
1. DISPLAY
2. PRINTER
3 . COMPUTER
MEMORY
DATA
TRANSMISSION
MEMORY
DATA
TRANSMISSION
DEVICE ERROR !
Error Display