KANOMAX 6162 Anemomaster - Manual (Page 27)

3. Measurement Mode 21
3.4.2 Other Measurement Mode Cannot be Used
Š When a measurement mode is set, only the configured mode can be used. Even if you select 2. MEASUREMENT
on the menu screen, a screen that allows you to select a measurement mode will not display. In stead you will
see the screen that allows you to configure the measurement setting for the set measurement mode. In order to
use other measurement mode, you need to deactivate the current selected mode.
[ Example] When Flow Rate mode is set;
Even if you select 2. MEASUREMENT, ·················································
3.4.3 How to Deactivate Pre-set Measurement Mode
Š In the same manner as when you configure program setting, display the <PROGRAM SET> screen.
When it is displayed, select 1. OFF.
Display Key Procedure
△ , ▽
SET
(1) Select 1. OFF.
Then press SET key.
OFF (2) 1. OFF will be highlighted.
Then, the menu screen will be displayed automatically.
△ , ▽
SET
(3) Select 2. MEASUREMENT to perform a measurement.
MENU
<MENU>
1. MONITOR
2 . MEASUREMENT
3. DATA OUTPUT
<FLOW RATE>
1. S-TIME (S) 01
2. DATA (M) 010
3. POINTS 016
<MEASUREMENT>
1. AVERAGE
2. INTERVAL
3. FLOW RATE
POWER SW ‒ ON
Air Volume Calculation
Measurement Standby
SET
The below screen will not
be displayed.
< PROGRAM SET >
1 . OFF
2. AVERAGE
3. INTERVAL
4. FLOW RATE
< PROGRAM SET >
1 . OFF
2. AVERAGE
3. INTERVAL
4.
FLOW RATE
< MENU >
1. MONITOR
2 . MEASUREMENT
3. DATA OUTPUT
4. MEMORY CLEAR
5. UTILITY