KANOMAX 6162 Anemomaster - Manual (Page 26)

3. Measurement Mode 20
3.4 Program Set
3.4.1 How to Pre-set Measurement Mode
Š If a measurement mode is preset, the instrument will enter the measurement standby when you turn it on.
To start a measurement, you only need to press START/STOP key.
Display Key Procedure
MENU (1) Press MENU key.
△ , ▽
SET
(2) Select 5. UTILITY.
Then press SET key.
△ , ▽
SET
(3) Select 3. PROGRAM SET.
Then press SET key.
△ , ▽
SET
(4) Select a measurement mode to be used.
Then press SET key.
(5) The cursor will move to the selected calculation mode.
Then, the measurement condition setting screen will be
displayed automatically.
△ , ▽
SET
(6) Configure measurement setting. Then move the cursor to 5. SET
OK, and press SET key.
The set measurement mode will be applied even when you turn
off the instrument.
If you turn the power on again, it will enter the measurement
standby mode.
OFF: No Program Set
AVERAGE: Average Value Measurement
INTERVAL: Intermittent Operation Measurement
FLOW RATE: Air Flow Measurement
POWER
SW-ON
Measurement Start
<AVE>
T: 01/10 M:015
N: 001/060 P:007
16.8 m/s
127 ℃
Calculation Result
<AVE RESULT>
AVE: 12.8 m/s
MAX: 15.8 m/s
MIN : 10.8 m/s
AVE: 126 ℃
MAX: 129 ℃
MIN : 123 ℃
Ready for measuring
Measurement Mode
Measurement Condition
<AVE> ready
T: 00/10 M:015
N: 000/010 P:007
16.8 m/s
127 ℃
< MENU >
1. MONITOR
2. MEASUREMENT
3. DATA OUTPUT
4. MEMORY CLEAR
5 . UTILITY
< UTILITY >
1. CALENDAR
2. ANALOG OUTPUT
3 . PROGRAM SET
4. RS-232C
< AVE >
1. S-TIME (s) 01
2. DATA (N) 10
3. MEMORY YES
4. PRINT YES
5 . SET OK!
< PROGRAM SET >
1. OFF
2 . AVERAGE
3. INTERVAL
4. FLOW RATE
< PROGRAM SET >
1. OFF
2 . AVERAGE
3. INTERVAL
4. FLOW RATE
<Measurement Setting
Screen>