KANOMAX 6162 Anemomaster - Manual (Page 29)

3. Measurement Mode 23
3.5.1 “Memory Over” Display
Œ When “SET OK!” is selected on the measurement setting screen, the instrument determines if there is enough
memory capacity. If there is not enough memory capacity left, “MEMORY OVER” will be displayed.
Ave. Value Measurement Intermittent Operation Air Flow Measurement Explanation
After configuring each
measurement condition,
select SET OK!.
Then press SET.
The cursor will move to
DATA (N) or POINTS
automatically.
Change the setting or delete
the data ("P28)
Š When repeating a measurement by using START/STOP key or a measurement mode is set, the instrument
determines if there is enough memory left on the measurement stand-by screen.
< FLOW >
1. S-TIME(S) 01
2. DATA (N) 010
3. POINTS 060
4. AREA(m2) 1.000
5. MEMORY YES
6. PRINT NO
MEMORY OVER
“MEMORY OVER” display
[Example] Average Vale Calculation
“MEMORY OVER” display
Calculation Result
Display Screen
When a calculation
program is set
Press START/STOP key.
Power SW-ON
< AVE >
1. S-TIME (s) 01
2. DATA (N) 100
3. MEMORY YES
4. PRINT NO
5 . SET OK!
< AVE >
1. S-TIME (s) 01
2. DATA (N) 100
3. MEMORY YES
4. PRINT NO
MEMORY OVER
< AVE >
1. S-TIME (s) 01
2 . DATA (N) 100
3. MEMORY YES
4. PRINT NO
5. SET OK!
< INT >
1. S-TIME(S) 01
2. DATA (N) 010
3. INT (min) 060
4. POINTS 024
5. MEMORY YES
6. PRINT NO
7 . SET OK!
< INT >
1. S-TIME(S) 01
2. DATA (N) 010
3. INT (min) 060
4. POINTS 024
5. MEMORY YES
6. PRINT NO
MEMORY OVER
< INT >
1. S-TIME(S) 01
2. DATA (N) 010
3. INT (min) 060
4 . POINTS 024
5. MEMORY YES
6. PRINT NO
7. SET OK!
< FLOW >
1. S-TIME(S) 01
2. DATA (N) 010
3. POINTS 060
4. AREA(m2) 1.000
5. MEMORY YES
6. PRINT NO
7 . SET OK!
< FLOW >
1. S-TIME(S) 01
2. DATA (N) 010
3 . POINTS 060
4. AREA(m2) 1.000
5. MEMORY YES
6. PRINT NO
7. SET OK!
< AVE >
1. S-TIME (s) 01
2. DATA (N) 100
3. MEMORY YES
4. PRINT NO
5 . SET OK!
<AVE> ready
MEMORY OVER
16.8 m/s
127 ℃