West Control Solutions KS 92-1 Programmer manual - Manual (Page 34)

Configuration level
Configuration parameters 34 KS 90-1
p / KS 92-1 p
Name Value range Description Default
3 measured value INP1
4 measured value INP2
5 measured value INP3
6 effective setpoint Weff
7 correcting variable y (controller output)
8 control variable deviation xw (actual value - internal setpoint) =
deviation alarm to internal setpoint
9 difference x1 - x2 (utilizable e.g. in combination with process va-
lue function “mean value” for recognizing aged thermocouples
11 Control deviation (=relative alarm) with suppression after
start-up and setpoint change without time limit
After switch-on or setpoint change, alarm output is suppressed,
until the process was within the limits once.
HC.AL
Alarm heat current function (INP2) 0
0 switched off
1 Overload short circuit monitoring
2 Break and short circuit monitoring
LP.AL
Monitoring of control loop interruption for heating 0
0 switched off / inactive
1 Active. If ti1=0 LOOP alarm is inactive!
Loop alarm active. A loop break is recognized, with Y=100% if
2 x ti passes by without appropriate reaction of process value
Hour OFF...999999 Operating hours (only visible with BlueControl
â
!) OFF
Swit OFF...999999 Output switching cycles (only visible with BlueControl
â
!) OFF
q Out.1
and
Out.2
Name Value range Description Default
O.Act
Method of operation of output OUT1 0
0 direct / normally open
1 inverse / normally closed
Y.1
Y.2
Controller output Y1/Y2 1
0 not active
1 active
Lim.1
Lim.2
Lim.3
Limit 1/2/3 signal 0
0 not active
1 active
LP.AL
Interruption alarm signal (LOOP) 0
0 not active
1 active
HC.AL
Heat current alarm signal 0
0 not active
1 active
HC.SC
Solid state relay (SSR) short circuit signal 0
0 not active
1 active
P.EnD
Message "Programm end" 0
0 not active
1 active