West Control Solutions KS 92-1 Programmer manual - Manual (Page 65)

7.3.3 Operation
Programmer operation (run/stop, preset und reset) is via front panel, digital inputs
or interface (BlueControl, superordinate visualization, ...).
Front panel operation
For programmer operation via the front panel keys, the digital input function
(
di.Fn r page 36) must be set to key operation.
Function key è can be used for switch-over to programmer or
controller . If programmer was selected, the func LED is lit.
Now, the programmer can be started or stopped via auto/manual key H (run LED
= ON or OFF). By pressing auto/manual key H during stop condition, the pro-
grammer jumps to the end segment. Press the key again to switch off the pro-
grammer (reset).
Operation via digital inputs
Functions start/stop and reset can be activated also via digital inputs. For this, pa-
rameters
P.run and P.oFF must be set for digital inputs ( r page 35, 36) at
CONF level LOGI (r page 35, 36).
Program/segment selection
Prerequisite: Programmer is in the reset or stop condition. How to select a de-
fined program (
Pr.no) followed by a segment (Pr.SG) is shown below. When
starting the programmer now, program operation starts at the beginning of the se-
lected segment in the selected program.
Preset
The preset function is activated via segment selection.
To permit preset in a running program, switch the programmer to stop, select the
target segment as described in the above section and switch the programmer to
run.
Programmer level
KS 90-1
p / KS 92-1 p 65 Programmer description
Щ Щ Щ Щ
119.9 1199 1199 1199
para para para para
200.0 Y 65 Pr.no Pr.SG
01 OFF 01 OFF Prog. 01 PresSegm
М М
М М