West Control Solutions KS 92-1 Programmer manual - Manual (Page 35)

Configuration level
KS 90-1
p / KS 92-1 p 35 Configuration parameters
Name Value range Description Default
FAi.1
FAi.2
FAi.3
INP1/ INP2 / INP3 error signal 0
0 not active
1 active
dP.Er
PROFIBUS error 0
0 not active
1 active: Profibus trouble, no communication with this
instrument.
Prg.1
Prg.2
Prg.3
Prg.4
Programmer Control track 1/2/3/4
0 not active
1 active
CAll
Operator call
0 not active
1 active
fOut Forcing OUT1 (only visible with BlueControl!) 0
0 No forcing
1 Forcing via serial interface
Configuration parameters Out.2 as Out.1 except for: Default Y.1 = 0 Y.2 = 1
q Out.3
and
Out.4
Name Value range Description Default
O.tYP
Signal type selection OUT3 0
0 relay / logic (only visible with current/logic voltage)
1 0 ... 20 mA continuous (only visible with current/logic/voltage)
2 4 ... 20 mA continuous (only visible with current/logic/voltage)
3 0...10 V continuous (only visible with current/logic/voltage)
4 2...10 V continuous (only visible with current/logic/voltage)
5 transmitter supply (only visible without OPTION)
O.Act
Method of operation of output OUT3 (only visible when O.TYP=0) 1
0 direct / normally open
1 inverse / normally closed
Y.1
Y.2
Controller output Y1/ Y2 (only visible when O.TYP=0) 0
0 not active
1 active
Lim.1
Lim.2
Lim.3
Limit 1/2/3 signal (only visible when O.TYP=0) 1
0 not active
1 active
LP.AL
Interruption alarm signal (LOOP) (only visible when O.TYP=0) 0
0 not active
1 active
HC.AL
Heating current alarm signal (only visible when O.TYP=0) 0
0 not active
1 active
HC.SC
Solid state relay (SSR) short circuit signal (only visible when O.TYP=0) 0
0 not active
1 active
P.EnD
Message "Programm end" 0
0 not active
1 active