West Control Solutions CI 45 - Manual (Page 46)

Name Value range Description
FrEq Switching 50/60 Hz (only visible with BlueControl!)
0 Mains frequency 50 Hz
1 Mains frequency 60 Hz
ILat suppress error latch (only visible with BlueControl!)
0 Enabled
1 Blocked
IExo Access to extended operation level (only visible with BlueControl!)
0 Enabled
1 Blocked
Pass OFF...9999 Password (only visible with BlueControl!)
IPar Access to parameter level (only visible with BlueControl!)
0 Enabled
1 Blocked
ICnf Access to configuration level (only visible with BlueControl!)
0 Enabled
1 Blocked
ICal Access to calibration level (only visible with BlueControl!)
0 Enabled
1 Blocked
T.Dis2 Entries for the text in display 2 (max. 5 digits)
(only visible with BlueControl!)
Linearization Lin
Only visible with BlueControl!
Name Value range Description
U.LinT Temperature-unit of linearization table
0 No unit
1 °C
2 °F
3 Kelvin
In.1 … In.32 OFF (from In.3)-1999...9999 Input 1 … Input 32
Ou.1 … Ou.32 -999.0 … 9999 Output 1 … Output 32
g
Value U.LinT defines the unit of input values specified for linearization of temperature values . Value entry
in Celsius despite display of the measured value in Fahrenheit is possible.
w
Specify the input signals mV, V, mA, % or Ohm dependent on input type.
w
For special thermocouples (S.tYP = 18), specify the input values in mV and the output values in the temperature
unit adjusted in U.LinT.
w
For special resistance thermometer (KTY 11-6) (S.tYP = 23), specify the input values in Ohm and the output value
in the temperature unit adjusted in U.LinT .
g
For resetting the instrument configuration to factory setting (default ),
r section 12.4, 6.17 (page 37)
Configuration level
46 Configurations UNIFLEX CI 45