Airedale TurboChill FreeCool 200kW - 1830kW - Manual (Page 138)

138 Chiller Technical Manual 7525355 V1.1.0_04_2013
Tr
ou
ble
sh
oo
tin
g
Chillers TurboChill™ Air Cooled and FreeCool
Code Description
Auto Reset
Unit Disabled
Component Disabled
Cause Action Default Alarm Type
AL060 Suction Press. Comp.3
• • The suction pressure is too
high / low at the compressor
Check: charge
/ system load /
sensor / suction
strainer
1 = Non critical
AL061 Discharge Press.Comp.3
• • The discharge pressure has
exceeded it limit
Check: the sensor
/ condenser/ shut
off valves
1 = Non critical
AL062 3Ph. Current Comp.3
• • Indicates there maybe an
excessive load on the system
1 = Non critical
AL063 Cavity Temp. Comp.3
• • The cavity temperature inside
the compressor is high
Check: the liquid
cooling line /
solenoid valve
1 = Non critical
AL064 Air/Water Temp. Comp.3
• • There maybe insufficient
water flow due to air gaps
Check: sensor
limits
1 = Non critical
AL065 Compress. Ratio Comp.3
• • The compression ratio of the
compressor is out of range
Check: condenser
/ evaporator loads
and settings
1 = Non critical
AL066 Bearing Reset Comp.3
• •
Low suction / liquid
Check: refrigerant
circuit
1 = Non critical
AL067 SCR Temp. Comp.3
• • Indicates insufficient cooling
to the SCR plate
Check: alarms
limits in the
compressor
1 = Non critical
AL068 System Lockout Comp.3
•
When a SCR / inverter / cavity
temperature fault occurs more
than 3 time in 30 minutes
Check: motor
cooling line and
solenoids valves /
cycle power
1 = Non critical
AL069 Inverter Temp. Comp.4
• • The temperature of the
compressor inverter is high
Check: liquid line
to the compressor
/ solenoid valves
1 = Non critical
AL070 Discharge Temp. Comp.4
• • The temperature of the
discharge gas is high
Check: refrigerant
charge / discharge
temperature
sensor
1 = Non critical
AL071 Suction Press. Comp.4
• • The suction pressure is too
high / low at the compressor
Check: charge
/ system load /
sensor / suction
strainer
1 = Non critical
AL072 Discharge Press.Comp.4
• • The discharge pressure has
exceeded it limit
Check: the sensor
/ condenser/ shut
off valves
1 = Non critical
AL073 3Ph. Current Comp.4
• • Indicates there maybe an
excessive load on the system
1 = Non critical
AL074 Cavity Temp. Comp.4
• • The cavity temperature inside
the compressor is high
Check: the liquid
cooling line /
solenoid valve
1 = Non critical
AL075 Air/Water Temp. Comp.4
• • There maybe insufficient
water flow due to air gaps
Check: sensor
limits
1 = Non critical
AL076 Compress. Ratio Comp.4
• • The compression ratio of the
compressor is out of range
Check: condenser
/ evaporator loads
and settings
1 = Non critical
AL077 Bearing Reset Comp.4
• •
Low suction / liquid
Check: refrigerant
Circuit
1 = Non critical
Alarms