HP StorageWorks XP Remote Web Console Software - Manual (Page 114)

The Delete Path command allows you to delete a path to an existing RCU.
To delete one or more paths from the connected MCU to an existing RCU:
1. Open the RCU Option dialog box, and check the Minimum Paths setting. If the remaining
number of paths will be less than this value, the delete path operation will fail. If needed,
change the Minimum Paths RCU option so that you can delete the desired path.
2. Click the RCU Operation tab, and click the MCU&RCU display button.
3. Select and double-click the desired MCU CU in the tree, and select the RCU for which you
want to delete path(s). Alternatively, select the RCU in the list, right-click and click Edit SSID(s)
& Path(s). All paths to the selected RCU are listed.
4. Right-click the path(s) that you want to delete, and click Delete Path. When the confirmation
message appears, click OK to delete the path(s), or click Cancel to cancel your request to
delete it/them. The preview list displays the path(s) that you want to delete. Delete is displayed
on the rightmost column of the selected path in the SSID/Path list.
5. Verify the requested operation(s) displayed in the preview list and the SSID/Path list.
To remove an operation, select the operation, right-click, and click Delete.
To cancel all operations, select all the operations in the preview list, right-click, and click the
Delete command, or click Cancel.
6. To start the operation(s), click Apply.
Adding and Deleting SSIDs for an RCU
Before adding an SSID, make sure that the remote copy connection is properly installed. You can
add three SSIDs to each RCU. Before deleting an SSID, make sure that the remaining SSIDs are
still valid, or the connection between the MCU and RCU may be lost.
The Add SSID dialog box (see “Add SSID Dialog Box” (page 114) ) allows you to add up to three
SSIDs to an existing RCU. To open the Add SSID dialog box, select the MCU&RCU display on the
RCU Operation window, select and double-click the desired MCU CU in the tree, select the desired
RCU, right-click the SSID and path list, and then click the Add SSID command.
Figure 39 Add SSID Dialog Box
To add one or more SSIDs to an existing RCU:
114 Performing TrueCopy for Mainframe Configuration Operations