HP StorageWorks XP Remote Web Console Software - Manual (Page 203)

NOTE:
•
If the first digit of the cmd_param is other than A , the storage system interprets this command
as pair establishment for TrueCopy for Mainframe Synchronous or ShadowImage for
Mainframe.
•
The consistency group nn must be registered prior to this command. Otherwise this command
will be rejected.
•
When MODE(RESYNC) is specified, the consistency group number n must be the consistency
group number to which the addressed device belongs. If a different number is specified, this
command will be rejected.
•
When MODE(RESYNC) is specified, the copy mode (synchronous or asynchronous) cannot
be changed. If a different copy mode is specified, this command will be rejected.
•
If the consistency group requirements are not satisfied, this command may/may not be rejected.
•
The delay option prevents command retry delay for this pair when sidefile is above the HWM.
If not specified correctly, command is rejected (F/M=04).
•
When cmd_param AGxxx is specified, this command ends before the actual pair
establishment/re-establishment successfully starts. Confirmation by CQUERY or IEA494I console
message is recommended after this command.
CSUSPEND
“Using CSUSPEND to Suspend TrueCopy for Mainframe Async Pairs” (page 204) describes how
to use the CSUSPEND command to suspend TrueCopy for Mainframe Asynchronous pairs and
groups. The syntax for the CSUSPEND command is:
For 3990-6 and -6E controller emulations:
CSUSPEND:
DEVN(X'dev#') PRIM(X'ssid' cmd_param X'cca')
SEC(X'ssid' serial# X'cca')[PRIMARY] [QUIESCE]
For 2105 and 2107 controller emulation, addressed device is M-VOL (new lss parameter for LCU
no.):
CSUSPEND
DEVN(X'dev#') PRIM(X'ssid' cmd_param X'cca' X'lss')
SEC(X'ssid' serial# X'cca' X'lss') [PRIMARY] [QUIESCE]
For 2105 and 2107 controller emulation, addressed device is R-VOL (new 'lss' parameter for LCU
no.):
CSUSPEND
DEVN(X'dev#') PRIM(X'ssid' X'cca' X'lss') SEC(X'ssid' cmd_param
serial# X'cca' X'lss') [PRIMARY] [QUIESCE]
If you need write access to an R-VOL, you must release the pair (CDELPAIR).
Overview of PPRC Commands 203