HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 216)

216 A - HP EFS WAN A CCELERATOR M ANAGER C OMMAND -L INE I NTERFACE
Hardware Commands
This section describes Error-Correcting Code (ECC) memory commands for the HP
EFS WAN Accelerator Manager. It contains the following commands:
‹ “hardware ecc-mem-check enable,” next
‹ “reset factory reload” on page 216
‹ “show hardware” on page 216
hardware ecc-mem-check enable
Description Enables Error-Correcting Code (ECC) memory check. The no command option
disables ECC memory check.
Syntax hardware ecc-mem-check enable
Parameters None
Example
minna (config) # hardware ecc-mem-check enable
minna (config) #
reset factory reload
Description Resets system to factory defaults and reboots the system.
Syntax reset factory reload
Parameters None
Example minna (config) # reset factory reload
minna (config) #
show hardware
Description Displays hardware information
Syntax show hardware
Parameters None
Example gen-sh12 # show hardware
Hardware Revision: B
Mainboard: Series 3000/5000 motherboard, ................. CMP-00072
Slot 0: 4 Port Copper GigE Network Bypass Card, ....... CMP-00074
Slot 1: (Empty)
Slot 2: (Empty)
Slot 3: (Empty)
Slot 4: 6 Port SATA RAID I/O Card, .................... CMP-00014
Slot 5: (Empty)