HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 59)

HP EFS WAN A CCELERATOR M ANAGER U SER ’ S G UIDE 59
3 -
S
ET
TI
N
G
U
P
R
EM
O
T
E
HP
EF
S W
A
N A
CC
ELE
RAT
OR
S
Setting SNMP Trap
Receivers You set SNMP trap receivers for a common profile in the Profile - SNMP Trap
Receivers page.
To set-up SNMP trap
receivers 1. Click the Setup Appliances tab to expand the Setup Appliances menu.
2. Click Common Profiles in the left menu to expand the Common Profiles menu.
3. Click Reports in the left menu to expand the Reports menu.
4. Click SNMP Trap Receivers in the left menu to display the Profile - SNMP Trap
Receivers page.
Figure 3-12. Setup: Reports - SNMP Trap Receivers Page
5. Use the controls to configure SNMP trap receivers for a profile, as described in the
following table.
Control Description
Settings will be applied to profile Select the name of the profile you want to configure from the drop-down list.
Clear trap receivers before send? Check this box and click Update to clear trap receivers before sending data.
Receiver IP Type the IP address for the SNMP trap. You must specify an IP address and not a host
name.
Community Type the SNMP community name.
Type Select v1 or v2c from the drop-down list to specify the SNMP software version.
Add Click Add to add the configuration to the Trap Receiver list.
Remove Selected Receivers To remove an SNMP receiver from the Trap Receiver list, click the check box next to the
name and click Remove Selected Receivers.