HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 54)

54 3 - S ETTING U P R EMOTE HP EFS WAN A CCELERATORS
To set-up alarms 1. Click the Setup Appliances tab to expand the Setup Appliances menu.
2. Click Common Profiles in the left menu to expand the Common Profiles menu.
3. Click Reports in the left menu to expand the Reports menu and display the Profile
- Alarm Settings page.
Figure 3-9. Setup Appliances: Profile - Alarm Settings Page
4. Use the controls to set alarms for a profile, as described in the following table.
Control Description
Settings will be applied to profile Select the name of the profile you want to configure from the drop-down list.
CPU Alarms Raise Alarm When CPU Utilization Reaches. Check this box to trigger an alarm if the
average and peak threshold for the Central Processing Unit (CPU) utilization is
exceeded.When an alarm reaches the rising threshold, it is activated; when it reaches the
lowest or reset threshold, it is reset. After an alarm is triggered, it is not triggered again
until it has fallen below the reset threshold.
Rising Threshold. Type a whole number to specify a percent of CPU utilization.
Reset Threshold. Type a whole number to specify a percent of CPU utilization.
Data Store Alarm Send email if stale data replaced by fresh data is less than ___ day(s) old. Check this
box to trigger an alarm if data in the data store is replaced with new data before the time
period specified.