HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 28)

28 2 - I NSTALLING AND C ONFIGURING THE HP EFS WAN A CCELERATOR M ANAGER
3. The system confirms your settings.
You have entered the following information:
1. Hostname: minna
2. Use DHCP: no
3. Primary IP address: 10.0.0.74
4. Netmask: 255.255.0.0
5. Default gateway: 10.0.0.1
6. Primary DNS server: 10.0.0.2
7. Domain name: example.com
8. Admin password: (unchanged)
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice:
The HP EFS WAN Accelerator Manager configuration wizard automatically
saves your initial configuration settings.
4. To log out of the system, enter the following command at the system prompt:
# exit
Step 3: Primary IP address? Enter the IP address for the HP EFS WAN
Accelerator Manager
.
Step 3: Primary IP address?
10.0.0.74
Step 4: Netmask? Enter the netmask for the network on
which the HP EFS WAN Accelerator
Manager is to reside. Step 4: Netmask? 255.255.0.0
Step 5: Default gateway? 10.0.0.1 Enter the default gateway for the network
on which the HP EFS WAN Accelerator
Manager is to reside. Step 5: Default gateway?
10.0.0.1
Step 6: Primary DNS server? Enter the primary DNS server for the
network on which the HP EFS WAN
Accelerator Manager is to reside. Step 6: Primary DNS server?
10.0.0.2
Step 7: Domain name? Enter the domain name for the network on
which the HP EFS WAN Accelerator
Manager is to reside.
If you set a domain name, you will not
need to specify the domain names when
you set up remote appliances to be
managed by the HP EFS WAN
Accelerator Manager.
Note: When you configure DNS server
settings, map hpwam to the IP address for
the HP EFS WAN Accelerator Manager.
Step 7: Domain name? example.com
Step 8: Admin password? HP strongly recommends that you change
the default password at this time. The
password must be minimum of 6
characters.
The default administrator password is
password.
Step 8: Admin password? xxxyyy
(2 of 2)