HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 82)

82 3 - S ETTING U P R EMOTE HP EFS WAN A CCELERATORS
5. Click Apply to Working to apply these settings to the specified interface.
When you apply page settings, the values are applied to the running configuration
but not saved permanently. The Save Configuration icon displays a flashing
orange arrow to remind you to save your configuration.
6. To save the settings permanently, click Save.
To revert to the running configuration, click Reset.
Additional Interface Settings LAN Speed. Select the speed from the drop-down list to set the speed for the in-path
LAN port. The default value is Auto.
If your network routers or switches do not automatically negotiate the speed and duplex,
you must manually set the speed and duplex for the primary interface.
The speed and duplex must match (LAN and WAN) in an in-path configuration. If they do
not match you might have a large number of errors on the interface when it is in bypass
mode, because the switch and router are not set with the same duplex settings.
Duplex. Select Auto, Full, or Half from the drop-down list to set the duplex speed for the
in-path LAN port. The default value is Auto.
If your network routers or switches do not automatically negotiate the speed and duplex,
you must manually set the speed and duplex for the primary interface.
The speed and duplex must match (LAN and WAN) in an in-path configuration. If they do
not match you might have a large number of errors on the interface when it is in bypass
mode, because the switch and router are not set with the same duplex settings.
WAN Speed. Select the speed from the drop-down list to set the speed for the in-path
WAN port. The default value is Auto.
If your network routers or switches do not automatically negotiate the speed and duplex,
you must manually set the speed and duplex for the primary interface.
The speed and duplex must match (LAN and WAN) in an in-path configuration. If they do
not match you might have a large number of errors on the interface when it is in bypass
mode, because the switch and router are not set with the same duplex settings.
Duplex. Select Auto, Full, or Half from the drop-down list to set the duplex speed for the
in-path WAN port. The default value is Auto.
If your network routers or switches do not automatically negotiate the speed and duplex,
you must manually set the speed and duplex for the primary interface.
The speed and duplex must match (LAN and WAN) in an in-path configuration. If they do
not match you might have a large number of errors on the interface when it is in bypass
mode, because the switch and router are not set with the same duplex settings.
MTU. Type a Maximum Transmission Unit (MTU) value in the text box. The MTU is the
largest physical packet size, measured in Bytes, that a network can transmit.
VLAN VLAN Tag ID. Type an numeric ID in the text box. Type 0 to leave the interface
untagged.
Bandwidth Limit Limit Optimized Bandwidth to. To limit optimized bandwidth, click this box and
specify a number of Kbps to set the limit.
The bandwidth limit applies only to the outgoing WAN interface and outgoing packets, it
does not apply to passed-through traffic. To limit a particular link to a certain bandwidth,
you must set the limit on the client and the server appliance.
Control Description