HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 65)

HP EFS WAN A CCELERATOR M ANAGER U SER ’ S G UIDE 65
3 -
S
ET
TI
N
G
U
P
R
EM
O
T
E
HP
EF
S W
A
N A
CC
ELE
RAT
OR
S
To add CLI commands
to a profile 1. Click the Setup Appliances tab to expand the Setup Appliances menu.
2. Click Profiles in the left menu to display the Profiles page.
3. In the Profile Name column, click the name of the profile for which you want to
display profile commands to display its commands page.
Figure 3-17. Setup Appliances: Profile: <Profile Name>
4. Use the controls to review and add CLI commands to the Commands list, as
described in the following table.
5. To save the settings permanently, click Save.
To revert to the running configuration, click Reset.
Control Description
Configuration Comment. Enter a comment that describes the commands you are adding to the profile.
Update. If you modify the above setting, click Update to apply your modification.
Commands The Commands list indicates the Index number and syntax for the CLI commands that
are sent to the remote appliance when the profile is pushed.
Remove Selected Commands. To remove commands from the list, click the check box
next to the command and click Remove Selected Commands.
Add Generic Command Command Index. Type an index number, based on the index that appears in the
Commands list.
Command. Type a CLI command. For a reference of CLI commands, see the HP
StorageWorks Enterprise File Services WAN Accelerator Command-Line Interface
Reference Manual.
Add Command. To add a command to the command list, click Add Command.