ARRI LOCPRO 35 - Manual (Page 14)

14
• Remove lens. See Chapter 7.2 (# 4)
• Check that the film gate frame and the surface of the
film track are clean.
• Insert the format mask with the film gate frame facing
the film gate (frameless side facing upward) by sliding
the mask in from the right side into the spring-loaded
support of the film track until the mask engages with
the film gate.
• Check the film gate mask for correct positioning.
• Replace lens.
• Replace optics cover.
Remove format mask:
• Open film channel with ”Film” – key
• Switch off main power supply.
• Remove optics cover. See Chapter 7.2 (# 2)
• Remove lens. See Chapter 7.2 (# 4)
• Remove the mask from the film gate by gently pressing
back the mask and then sliding it back out to the right
➪ photo .
• Replace lens.
• Replace optics cover.
Initial Operation