ARRI LOCPRO 35 - Manual (Page 38)

38
6.7.4 ”Mode” key
The ”Mode” key ➪ photo only functions, when the Master
Control Knob is in the ”0” position. Each stroke of this key
leads to the next lower menu level, i.e. from mode 1 to
mode 2, etc. (see chapter 6.6).
Mode 1: Normal viewing
The display shows the frame rate in fps on the
left sideand the frame counter on the right (if an
error occurs, an ”error” message will appear).
Mode 2: Video masking
Depress ”Mode” key once.
A video mask can then be positioned on all four
sides, and the masking function can be switched
on and off. The masks are only visible on the
video monitor. (see chapter 6.5.1 ”Masking of
Video Images”).
Mode 3: Frame rate selection
Press ”Mode” key twice.
The programmed frame rate can be changed
by repeatedly pressing of the ”Reset” key
(higher values) or of the ”Film” key (lower values).
Mode 4: Unit configuration
Press ”Mode” key three times.
In this mode the film type and film core diameter
can be selected (see chapter 6.6).
Functions
“Mode“- key