Konica Minolta FK-102 - Manual (Page 317)

FAX terms - (continued)
Appendix-9
Appendix
C
■ Compulsory mem. Rx
The function to store the received document and print the document as necessary.
■ Confidential communication
The function to exchange private information with specific persons. The originals sent by the
confidential communication are stored in the receiver's confidential box and they are not
printed at the reception. They are printed after the certain operation such as inputting the
password.
D
■ Dialing method
There are two methods: PB or Pulse.
E
■ ECM (Error Correction Mode)
The error correction mode for G3 communication. It communicates with a destination during
checking whether data is sent to the destination properly or not. If not, it sends the data again.
If the destination supports the ECM, data is transmitted in ECM unless you set the ECM off
mode.
F
■ Factory default setting
The value set at the factory. You can change some initial values by the Key Operator mode. It
is useful to set the value that you use frequently as the initial value.
■ FAX ID
The ID code to recognize each other at the fax communication. The telephone number is usu-
ally registered as the FAX ID.
■ F-code
It defines the use of the sub-address of T.30* standardized by ITU-T. You can use various
functions of the F-code in the fax communication among facsimiles supporting the F-code
function even if their manufactures are different. In this machine, the F-code is used in the bul-
letin board, relay request, confidential communication and ID transmission. (* This is one of
the communication standards.)
■ Frame erase Tx
The function to erase dark bands reproduced when the original is a book or read with the
RADF left open.